12/9/2023 0 Comments Rheem piezo igniter replacement![]() Now, use an adjustable wrench to unscrew the pilot tube and the gas supply tube from the control valve.Don’t forget to remove the bottom cover from the unit.Detach both igniter wire and the thermocouple wire that leads into the gas control valve. ![]() Shut the gas supply off to the unit and set the gas control knob to the Off position. ![]() Stick to the following steps to learn how to clean igniter on a water heater: In other words, you can’t ignite your water heater. As a result, it will not work the way it should. Over time, carbon and fuel residue form a layer on the thermopile. Honeywell water heater thermopile won’t work if it gets covered with carbon deposits. Indeed, the white connector shouldn’t touch these components. Lastly, make sure you keep the white connector far from the metal pilot tube, manifold tube, and manifold door. If the white or the orange igniter wire comes loose, ensure you tighten it up or insert into the white connector. It should be firmly inserted into the white connector. Start with inspecting the igniter wire (it’s either white or orange). In short, the igniter doesn’t work if its wiring comes out of the white connector. As a result, the igniter fails to ignite the burner. If the igniter wires come loose from their connector, the controller will receive no signal for ignition. Igniter Wire Comes LooseĮxtracted igniter wires that come out of the white connector are the first I blame most. Your Honeywell water heater igniter is not working due to loose igniter wiring, dirty thermopile, and bad igniter.īelow, I will break down everything you need to know to let the igniter function again.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |